APACHE
SMART Lithium Polymer Chargers
SMART CHARGERS are intended for Li-Poly battery
only!!!!
Please read
the manual carefully before using... it
can make a difference between having a great time on the flying
field or NOT having a great time at the flying field...YOU
CHOOSE!!!!
With the introduction of the new chargers from Apache,
technology has taken a major step forward in the safe charging of
Lithium Polymer Batteries. In the past, there had been poor
reliability in charging systems, which caused in many cases
destroyed batteries, which is both costly and unsafe.
Apache looked at this problem and determined that the
best possible system was a combination of manual setting by the
user, plus an extremely sophisticated detection routine to check the
voltage setting before charging begins. Using jumpers to set voltage
and charge rate also insures that settings do not change
inadvertently, as they can with chargers using rotary dials or
software systems.
We believe that the Apache SMART Charger line is the
safest on the market today. In a recent test of the safety detection
circuit they contain, more than 1000 improper combinations of
battery and jumper settings were connected, and the chargers were
100% accurate in detecting these errors - emitting a warning light
and refusing to charge in each case. Human error is much more likely
than charger error, and the Apache oversight circuit is highly
recommended insurance for that rare case when your attention might
wander for a moment.
Apache Li-Poly 1250 Charger
Dedicated Lithium Polymer charger for 1 to 2 cells
(3.7V ~ 7.4V) 80 mAh to 1200 mAh charging rates Charge 1 to
2 cells in series from 12V power source. (2-cell charger)
Trouble-free manual cell count/charging voltage setting
Automatic OverSight - voltage-check safety circuit. Input
and output reverse polarity protection. High-Quality silicone
cabling Female JST connector to match E-Tec Packs Safely
charge any Lithium Polymer battery to 100% capacity
Sales Price=
$24.95
Apache Li-Poly 2500 Charger
Dedicated Lithium Polymer charger for 1 to 4 cells
(3.7V ~ 14.8V) 250 mAh, 700 mAh ,1200 mAh ,1700 mAh,2000 mAh
,2500 mAh charging rates Charge 1 to 4 cells in series from 12V
power source. (4-cell charger) Trouble-free manual cell
count/charging voltage setting Automatic OverSight -
voltage-check safety circuit. Input and output reverse polarity
protection. High-Quality silicone cabling Female JST
connector to match E-Tec Packs Safely charge any Lithium Polymer
battery to 100% capacity
Sales Price=
$49.95 |