Click to Enlarge

C40 Series Brushless Motor System- bolts directly into the standard motor location, utilizing the normal 3mm mounting screws. All standard heatsinks and adapters should be utilized. The motor must be Soldered directly to the Speed Control. We highly recommend the use of a Deans Ultra connector (Reversed Polarity will destroy the Controller!) We recommend the Sanyo 3000HV or Panasonic 3000 Ultra Metal packs for Best Performance. Select Gearing as you would for a " Low Turn Mod. Motor"

 

Chassis	Motor	Cells	Spur	Pinion	Run time
Factory Team-TC3	C40 8T	6-3000NiMh	72T-48P	21T-48P	8Min (Racing)
Factory Team-TC3	C40 7T	6-3000NiMh	72T-48P	18T-48P	6Min (Racing)
The Associated Factory Team TC3 has proven to be an excellent Brushless Racing Chassis. The design lends itself to the Very High Torque and Power the Hacker Brushless Motor System provides. (We have completed over 100 Club Races with this chassis/ brushless Motor combo) Performance: C40 8T We like the to run this motor on the Short tracks, and Low traction "Parking Lot" tracks. Be sure to set the Differential "Tight" like on the low turn Mod. motors. Typically the Pinion ranges from 19 to 23 Teeth. We use the timing mode 1, frequency mode1 and current Limit 3-60amp for racing conditions.This system is very fast and behaves similar to a 9turn Mod. with much more run time and better acceleration. Performance: C40 7T We like the to run this motor on the Long tracks, and High traction (Carpet) tracks. Be sure to set the Differential "Tight" like on the low turn Mod. motors. Typically the Pinion ranges from 16 to 20 Teeth. We use the Timing mode 1, Frequency mode 1 and Current Limit -60amp for racing conditions. This system Catapults the car out of the corners to a very high Top speed. FOR Advanced Racer Only!!!